Das Forum für intelligente VAG-Nachbau-Elektronik...
CH/LH  function over VI - Druckversion

+- Das Forum für intelligente VAG-Nachbau-Elektronik... (http://forum.msh-elektronik.de)
+-- Forum: Lichteffekt-Steuergerät für LED Tagfahrleuchten (/forumdisplay.php?fid=20)
+--- Forum: Bedienung (/forumdisplay.php?fid=23)
+--- Thema: CH/LH  function over VI (/showthread.php?tid=174)


CH/LH  function over VI - flo2203 - 22.02.2010 09:07

Hi,

you can have you CH / LH function again (for CH / LH  foglight cars)

if you use this solution. The plan is for one side, you must apply to the bought sides.


thank to michi schmidt


RE: CH/LH  function over VI - s_heinz - 24.02.2010 09:50

Hello,

in the shown solution you need 3 diodes (for each side! = 6 in common) and you 'override' the control box.
You can do it much easier:
By using the V2 Basis, you don't need any external diode. You have then only to connect one foglight to the additional input of the V2 Basis.
By using the V1 ex, you have only to use 2 external diodes connecting the ignition/DRL signal and one foglight signal to the ignition input (pin 1) of the control box.

That's it! Wink


RE: CH/LH  function over VI - flo2203 - 24.02.2010 09:52

thank you very much HEINZ

you mind 2 diodes on each sides, one on foglight input, and one on
ignition /DRL input ?

f

flo2203 schrieb:
thank you very much HEINZ

you mind 2 diodes on each sides, one on foglight input, and one on
ignition /DRL input ?

f


sorry now i think i understand i need just ONE foglight signal, so i need one diode on this one , and one diode on ignition plus. can you indicate the senses of this two diodes please ?

thank you,f


hi,

well.... i allready have an input from foglight to pin 6 . it's ok when i use the same in pin 1( with diode of course) ?


RE: CH/LH  function over VI - s_heinz - 25.02.2010 09:49

Hi,

do you use the V2 Basis or the V1 ex?

You wrote "pin 6". Then ist's the V1 ex, right?

By using the V1 ex it's not really necessary to connect the fog signal to pin 6 in your case.
You can connect ignition/DRL via a diode to pin 1 (Zündplus). Connect ignition/DRL signal to anode (+) and the cathode (-) of the 1st diode to pin 1 of the control box.
Connect fog light signal via a 2nd diode to pin 1. Connect fog light signal to anode (+) and the cathode (-) of the diode to pin 1 of the control box.
Pin 6 of the control box can be left free then.


RE: CH/LH  function over VI - flo2203 - 25.02.2010 09:55

thank you for you answer

i use the V 1ex model indeed